Solutions

Network broadcast

Modified on 2025-06-10 13:35:44 +0200

I have a backup process over the network which is 1 server flow to a backup server daily, the back up data about 300gb full backup, with speed about 800 mbps / minute over the network.

However in PRTG map not only the source server and backup server that having bandwidth spike until 800mbps, but all the port showing in the switch shown in PRTG having the same spike, same amount and same time, which make the networks latency very high, is that normal?

Thanks YJH

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

thank you very much for using PRTG. May I ask, could you please send us some screenshots showing the issue? Which sensor(s) are you using? Also, is it a switch or maybe a hub here?

best regards.

Sep, 2014 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Network broadcast

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.