How can i make Teamed Windows 2012 Server Intercace visible for the sensor selection?

Modified on 2025-06-10 13:36:40 +0200

How can i make a teamed windows 2012 server Interface visible in the sensor selections?

I only see the 2 physicaly Interfaces, but not the "virtual" one... :(

Thank you for a the help Volkan

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

The issue is that there is no information about bandwidth usage through WMI or Performance Counters for NIC Teams but you should be able to monitor this through SNMP. Please see the related article here.

The other option is to use the sensor factory sensor which is also mentioned in that article.

Sep, 2014 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How can i make Teamed Windows 2012 Server Intercace visible for the sensor selection?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.