When creating a new SNMP disk free sensor on a linux server only a few directories show up. I want to monitor some additional directories via this sensor. How do I specify additional directories for monitoring?
How do you specify additional directories to be monitored by the SNMP Disk Free sensor?
Modified on 2025-06-10 13:36:48 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
I think this is the same post as the one before but I'll post the info again here. Let us know if this works for you.
If you want to use SNMP you can try to set up an SNMP Library sensor and use the Paessler Common Library as the OID library and you should be able to see all of the mountpoints available through SNMP.
Sep, 2014 - Permalink