Solutions

SNMP "Too Big (SNMP error # 1)

Modified on 2025-06-10 13:37:43 +0200

was trying to add sensors to me Core switch and got a "Too Big (SNMP error #1) on the System Health Other and System Health Temperatures sensors.

is there any way to brake up these into multiple sensors with a few channels on each?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

thank you very much for using PRTG. Please try switching to Single Get as the Request Mode under SNMP Compatibility Options on the Settings of the Parent device to those sensors:

best regards.

Aug, 2014 - Permalink

Thank You! that worked.

Aug, 2014 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

SNMP "Too Big (SNMP error # 1)

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.