Unfortunately our harddisk is completely full - 6,5 MB left, so prtg has stopped working and i'm not able to logon to enterprise comsole.
Can i move some historic sensor data to another harddisk to get prtg up and running and will there be other impact beside loosing older data ?
Many thanks in advance.
Article Comments
Hello
Best solution:
Use the "Historic Data Purging" settings you find in PRTG under:
Setup -> System Administration -> Core & Probes
In your case the solution might be to remove old data.
Not recommended if not absolute necessary, but should only have impact on using historical data for reports.
1) Stop the PRTG service
2) Backup your PRTG data folder!!!
3) Have you remembered to backup your PRTG data folder?
4) Delete old data files
5) Start PRTG service
---------------------------------------------
Jens Tore Fremmegaard, ServerParkering AS
Paessler Certified Monitoring Professional
Aug, 2014 - Permalink
Hello,
please also see the following article to change the Data Directory of your PRTG.
best regards
Aug, 2014 - Permalink
Hello
Best solution:
Use the "Historic Data Purging" settings you find in PRTG under:
Setup -> System Administration -> Core & Probes
In your case the solution might be to remove old data.
Not recommended if not absolute necessary, but should only have impact on using historical data for reports.
1) Stop the PRTG service
2) Backup your PRTG data folder!!!
3) Have you remembered to backup your PRTG data folder?
4) Delete old data files
5) Start PRTG service
---------------------------------------------
Jens Tore Fremmegaard, ServerParkering AS
Paessler Certified Monitoring Professional
Aug, 2014 - Permalink