How do you add a sensor(s) on a Cisco 3750 Switch to show what VLAN/Macs/IP's are on a switchport?

Modified on 2025-06-10 13:39:21 +0200

I am wanting to add sensors to my PRTG to monitor what Vlan the switchport is configured to (I know i can do show commands on the switch but it would be nice to have it in PRTG), also what mac's and IP/s are connected to that port. I would like to do this with a custom SMNP sensor OR is their an easier way?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

this is not possible out of the box with PRTG at the moment.

You would have to use custom sensors to achieve this, sorry.

Aug, 2014 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How do you add a sensor(s) on a Cisco 3750 Switch to show what VLAN/Macs/IP's are on a switchport?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.