I am trying to generate a report that will show the average uptime over a quarter in percentage of a WMIUPTIME sensor.
How to create a Quarterly Up Time report?
Modified on 2025-06-10 13:39:37 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
You can do this by changing the channel settings to show the System Uptime Channel data as "Display in percent of maximum". Then when you run the report, it will show you the percentage average based on your maximum value. Please note that the maximum is in the unit of seconds.
Aug, 2014 - Permalink