Solutions

Netflow Cisco Router

Modified on 2025-06-10 13:39:48 +0200

We want to monitor our Cisco routers with NetFlow. The routers will send the data from different locations to our main prtg server over WAN. It is possible to display the sensor below the remote probe of the location or only below the main server? We get our routers preconfigured and it would be a lot easier with one ip adress for the netflow configuration.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

If you send the flow data to the IP of the main server/local probe, then you can only place the netflow sensors somewhere under that probe.

If you need them under the remote probe, you need to configure the devices to send the flows to the remote probe IP.

Jul, 2014 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Netflow Cisco Router

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.