File content sensor- Logon failure: The network name cannot be found(67) (code: PE029)
Modified on 2025-06-10 13:39:54 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
I'm trying to create a file content sensor and I continue to receive the above error. Other sensors are working and I'm also using a correct login/password to run the sensor. Any ideas? Thanks
Article Comments
Hello,
which other sensors do you have scanning the exact same target? Can you please try if a normal File Sensor does "see" the target file?
best regards.
Jun, 2014 - Permalink
It doesn't see the file under the file sensor. The HTTP Advanced sensor works along with PING. All SNMP sensors fail, so I'm guessing that port isn't open on the target host. I'll take a deeper look.
Jul, 2014 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
which other sensors do you have scanning the exact same target? Can you please try if a normal File Sensor does "see" the target file?
best regards.
Jun, 2014 - Permalink