Solutions

Alarm on uptime less than

Modified on 2025-06-10 13:39:59 +0200

I would like to be able to alarm if a machines uptime is less than, say, 5 or 10 minutes. We are not running snmp on these servers but we do track uptime with the WMI sensors. Is there a way I can generate an alarm if the uptime changes to less than 10 minutes?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

The best way to do this would be to set up channel limits. You can set up the lower error limits and then if the value is below a certain time, it will alert. The channel limits will be in units of seconds so make sure you put in the correct amount of seconds.

Jul, 2014 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Alarm on uptime less than

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.