Solutions

Display Channel only in map

Modified on 2025-06-10 13:41:35 +0200

I have a sensor set to collect # of active users in a wmi terminal service session.

When designing the map I am trying to have just the # of users displayed instead of the default information. Is it possible?

Thanks,

Tyler

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Dear Tyler,

could you please upload some screenshots showing the "Overview"-Tab of the sensor, what you get on the Map, and then maybe illustrate what you would like to see on the map? THank you!

best regards.

Jul, 2014 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Display Channel only in map

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.