Can the time setting on the warnings be changed?

Modified on 2025-06-10 13:42:23 +0200

We would like to change the amount of time a device is in the warning state before it goes to an error. Are we able to change this for a group of devices or in the configuration of PRTG?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

I'm sorry, but is not possible to set timing conditions on state changes for sensors. State changes will always be immediate. Please use the Latencies on Triggers to delay notifications.

best regards.

Jun, 2014 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Can the time setting on the warnings be changed?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.