Solutions

network monitoring

Modified on 2025-06-10 13:43:41 +0200

Hi, I just wanted to find out how many sensor would we need if we were to monitor our SAN storage levels, would it be one for each storage disk/volume?

Regards

Kwok

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Generally that is how it would work. There are some sensors for windows that allow you to monitor multiple volumes but for a SAN like you are talking about, you would likely need a sensor for each volume that is attached.

Jun, 2014 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

network monitoring

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.