SNMP HP LJ - No Response Error 2003
Modified on 2025-06-10 13:44:01 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
Evaluating PRTG on our local network. I am trying to set up sensors for an HP Laserjet 1300n. I have already enabled read/write on the LJ.
When I attempt to add the built in SNMP HP Laserjet sensor, it always gets error of "No Response - check firewall...etc...-2003"
Any ideas?
Article Comments
Hello,
Can you try to use our SNMP Tester, run it on the PRTG Host, and Read the Device Uptime from the target device? Which results do you get in the tester? Please post the result logfile from the Tester.
best regards.
Jun, 2014 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
Can you try to use our SNMP Tester, run it on the PRTG Host, and Read the Device Uptime from the target device? Which results do you get in the tester? Please post the result logfile from the Tester.
best regards.
Jun, 2014 - Permalink