Hi,
After an update to version 14.2.10.2114 of PRTG, I now seem to have a lot of up log entries. But no where is there a warning or down, this is happening on 3 different PRTG systems.
Article Comments
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Good morning Torsten,
It is for up statuses, almost as if the sensor has been checked for th first time.
Jun, 2014 - Permalink
Can you please upload a screenshot showing what you are referring to? Thank you.
Jun, 2014 - Permalink
These log entries are fully normal upon sensors going into UP state. Nothing was changed in this regard to previous versions of PRTG.
Jun, 2014 - Permalink
Hi Torsten,
I still have a lot of up status log entry, so I have updated the image I posted with the log from a sensor.
Jun, 2014 - Permalink
What exactly happened before those UP-Entries? Was PRTG itself down? Is this on a Remtoe Probe?
Jun, 2014 - Permalink
Hello,
thank you very much for your KB-Post. May I ask, which exact "log entires" you are referring to?
best regards.
Jun, 2014 - Permalink