Notification if a sensors is paused or deleted?

Modified on 2025-06-10 13:44:49 +0200

Is it possible to get a notification if any sensor is paused or deleted?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Unfortunately there is no way to do this with PRTG. One of the main points of a paused sensor is to not send out notifications. Also, with the deletion of a sensor, this is something that is only done by the admin and this can be seen in the history for a group but there is no way to notify for it.

Jun, 2014 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Notification if a sensors is paused or deleted?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.