Is it possible to put port names on the connector between two devices? Or better, to bind two ports (sensors) to a certain connector? Something like hovering over a connector between two devices which gives you instant information which ports are used for that link.
I know it's possible to insert the port sensor object directly, but i'd like a basic topology drawing on the map while inserting only device objects instead of multiple sensors per device.
Article Comments
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Hi,
That is rather unfortunate. Are there any plans of implementing this? The maps feature would benefit very much from this simple addition.
May, 2014 - Permalink
Hello,
thank you very much for your KB-Post. I'm very much afraid the only way will be to indeed use the SNMP Traffic Sensors (for each port) separately and then use connection lines from this. Sorry.
best regards.
May, 2014 - Permalink