Is it possible to start a network Auto-Discovery only for SNMP sensors (without PING and WMI). So only devices with active SNMP settings should be recognised/add to the PRTG system.
SNMP- Auto-Discovery only
Modified on 2025-06-10 13:46:06 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
When defining the auto-discovery select to use "Automatic sensor creation using specific device template(s)." You can then select the templates you would like to use.
May, 2014 - Permalink