Solutions

Report

Modified on 2025-06-10 13:46:23 +0200

Hello, we need to make report about not working sensors every day at morning. How do I need to configure report?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

thank you very much for your KB-Post. Sorry, a report filtered on the state(s) of sensors is not possible. But normal reports with data-tables have a part called "Sensor Status History" so you can see for the sensors when a sensor was down/up/etc.. Otherwise maybe the solution of the following article helps: How can I create a report about the notifications, alarms and downtime of a sensor?

best regards.

May, 2014 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Report

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.