Solutions

Hp Proliant SNMP Raid status

Modified on 2025-06-10 13:46:48 +0200

I am monitoring a server using this check. However a raid controller lost a drive and status returns "Warning". In my setup I consider this "Critical"! Can I change it somehow?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

thank you very much for your KB-Post. Please check the Channel Settings of the Sensor, either change the Error-/Warning-Limits on the sensor, or if the sensor uses a Lookup, please change/edit the Lookup-File.

best regards.

May, 2014 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Hp Proliant SNMP Raid status

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.