Solutions

got "No such object (SNMP Error #222)"

Modified on 2025-06-10 13:47:18 +0200

Hello,

I contact you because i have an issue with the PRTG.

I install it on a Windows 7 machine. It seems to work fine, but i have a problem when i am trying to monitor a Debian machine.

I have set differents sensor that are working on it but two of them doesn't work: - Disk Free sensor (SNMP) - Memory information sensor (SNMP)

I have the following error: "No such object (SNMP Error #222)" for both.

And the other sensors work: - SNMP disponibility - PING - HTTP - Traceroute

Thank you for helping me.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

This error meaning that the configured OID is not correct because it do not exist or because it bad written

If you have a SNMP Custom Sensor, you must check the configuration.

Best regards

May, 2014 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

got "No such object (SNMP Error #222)"

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.