I'm just wondering how to access device through telnet command from PRTG network monitor i can setup the sensor port to monitor only the port but i can not access the device itself, So is it possible?
how to log on to device using telnet?
Modified on 2025-06-10 13:47:43 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
thank you very much for your KB-Post. You can either try using the Command-Option on a Port Sensor or a self written script as Custom Exe Sensor.
best regards.
May, 2014 - Permalink