Hello,

I searched here, but was not able to find how to do this. The PRTG manual does not talk about this neither.

I have almost 7000 sensors in my installation and I would like to create a remote probe on another VM and move some of the devices from Local Probe to the Remote probe.

Can I just simply move the folder of PRTG main system to another VM and then convert the newly system to remote probe?

Thank you.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

thank you very much for your KB-Post. To install a Remote Probe on a new machine, please simply follow the PRTG Manual on this.
To move devices then from the Local to the new Remote Probe, you can use Drag & Drop on the Management-Tab in the PRTG AJAX Webinterface.

best regards.


Apr, 2014 - Permalink