How can i add sensors when the sensors exist in different devices and IP address of each device is different.
Sensors addition
Modified on 2025-06-10 13:48:42 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
thank you very much for your KB-Post. You can either Clone such sensors to the other target devices (using Drag & Drop on the Management-Tab in the PRTG AJAX Webinterface).
Or you can use device templates and the Auto-Discovery to create / add sensors to several devices in one go.
best regards.
Apr, 2014 - Permalink