Solutions

Problem beim Klonen

Modified on 2025-06-10 13:49:51 +0200

Hallo,

wenn ich ein Gerät klone, erscheint in der Box, "Wählen Sie eine Gruppe für das neue Gerät" kein Gerätebaum um eine Gruppe auszuwählen. Das Feld bleibt einfach leer. Das gleiche Verhalten beim klonen eines Sensors. Wir setzen V12.3.3.3855 ein.

MfG Martin Wegner

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hat sich erledigt.

Apr, 2014 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Problem beim Klonen

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.