How do I setup an automatic sensor for the new Cisco 2500 Series Wireless Controller? This wireless controller will monitor multiple CISCO Access points that will not have a static IP Address. I also would like to monitor those devices as well, however, they were setup with DHCP.
Setup Monitors for new Cisco 2500 Series Wireless Controller
Modified on 2025-06-10 13:50:43 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
thank you very much for your KB-Post. If PRTG does not ad sensors, when you run an Auto-Discovery against the WC, then I'm afraid you can only check if Cisco offers any MIB-Files that you can import with our MIB-Importer to monitor the target then with SNMP Library Sensors.
Best regards.
Mar, 2014 - Permalink