Hello,
Is it possible to set that a sensor will go into an error/warning status only after a certain period of time?
Thanks, Yaron
sensor status mode
Modified on 2025-06-10 13:52:37 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
thank you very much for your KB-Post. I'm afraid a delay or latency on a status change of a sensor (into warning or error state) is not possible or planned. We believe these changes have to be immediate. Please instead work with the latencies on the notifications.
best regards.
Mar, 2014 - Permalink