custom senor
Modified on 2025-06-10 13:52:58 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
Hi All,
I have a custom sensor on hand which is a *.exe file. I have ran it from the exe file and it shows
[0:05 - connection available]
How do I go about inputting this custom sensor inside PRTG. All help and advice would be greatly appreciated!
cheers,
Alex
Article Comments
Hi,
you would have to place the EXE file in the folder <PRTG Install Directory>\Custom Sensors\EXE. Now go to the web interface and add a new EXE/Script Sensor. From the dropdown EXE/Script you are able to select your EXE file.
Best regards
Mar, 2014 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi,
you would have to place the EXE file in the folder <PRTG Install Directory>\Custom Sensors\EXE. Now go to the web interface and add a new EXE/Script Sensor. From the dropdown EXE/Script you are able to select your EXE file.
Best regards
Mar, 2014 - Permalink