Hello, Based on this post: https://www.paessler.com/knowledgebase/en/topic/59803-my-event-log-sensor-ignores-changes-in-the-event-log-what-can-i-do

I have configured the sensor and when I tried to configure the limit I received an error (I couldn't reply to that post so I open a new one).

Ajax Error (Bad Request) 14.1.8.1308 The validation of the data provided failed due to the following: Upper Error Limit (#/s): "0,0001" is not a floating point number.

Please advise.

Regards, Yaron

Article Comments

Hi,
have you tried using a dot . as decimal delimiter?
Additional, you might set an upper error limit of 0 as well which will trigger an alert as soon as a Event is recognized.
Best regards


Mar, 2014 - Permalink

Hi,

I copied the value from the example, the example uses a comma and not a dot (0,0001). I was not sure if it would work with a dot, i corrected and there isnt any error message.

Thank you, Yaron


Mar, 2014 - Permalink