As per requirement I need to configure a SQL sensor only with Warning Threshold value.
But for the notification below condition should be followed
If 6 consecutive warnings Alert have been fired.
then PRTG will now send a down Alert every minute
Can anyone help me with this.
Article Comments
Hello,
thank you very much for your KB-Post. I'm afraid it's not possible to set time-conditions for state changes on sensors. State Changes will be immediate. The recommendation is to use the error limit directly, and then use a latency, to send a notification only after a certain time (which you consider "critical" then).
best regards.
Mar, 2014 - Permalink
Hello,
thank you very much for your KB-Post. I'm afraid it's not possible to set time-conditions for state changes on sensors. State Changes will be immediate. The recommendation is to use the error limit directly, and then use a latency, to send a notification only after a certain time (which you consider "critical" then).
best regards.
Mar, 2014 - Permalink