How I can configure snmp on AIX ? Do i need to use snmp v3 or I can use v2 or v1?
I don't want to use ssh sensors.
I've configured a community in snmpv3.conf, a group and Ip's pemitted but nothing about authentication or cypher as prtg guru configuration ask for.
Have you a note or an article about this??? Thanks
Article Comments
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
With v1 and v2 you can configure just the community name with v3, you would have to configure a username password and encryption. Unfortunately we do not have an AIX system here and we don't support these systems as a result so you would need to find the resources about setting this up from IBM. Some information I found is in this link. You can also use the SNMP tester to run a walk, an interfaces scan or an uptime scan to see if this is working properly.
Feb, 2014 - Permalink