Solutions

PRTG Sensor figures

Modified on 2025-06-10 13:55:25 +0200

I am monitoring a Cisco 887VA router through PRTG and am monitoring the ATM interface for bandwidth but it is giving me figures of 300,00 Kbits/sec which is obviously not correct, is there some config I am missing on this?

I have several routers of the same model monitored and some are ok and others are not.

I have compared firmware of the device and interface cards and they are identical as are the IOS versions.

Help would be greatly apreciated.

Many thanks

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

thank you very much for your KB-Post. May I ask, could you please upload a few screenshots showing this issue?

best regards.

Feb, 2014 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

PRTG Sensor figures

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.