Hi Paessler, it would be very helpful, if newly created sensors would not just be named with a trailing sequential number, but with the hostname after the sensor's name (and the maybe a trailing number if more then one).

e.g. PING %SERVERNAME% (1)

Especially since many reports or references to sensors in PRTG do not show their host, this is quite important to us.

Is there any way to achieve this? Variables maybe?

Thanks in advance for your help,

Matin Schiemann

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

thank you very much for your KB-Post. I'm very much afraid, in the moment this is not possible, not even with 'tricks'. We will put this on the wishlist though! Thank you very much for the feedback, we really appreciate it!\

best regards.


Feb, 2014 - Permalink