Solutions

Default RDP data

Modified on 2025-06-10 13:56:26 +0200

With RDP 8 and Remote FX this protocol now uses both TCP 3389 and UDP 3389 on the standard graphs etc it has RDP. Could you please advise if this RDP is both the TCP and UDP 3389 data or just the TCP 3389.

Thanks

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

I apologize for the late reply on this, we've added the UPD-Port to the definitions for the Sniffer Sensor. This should be released to stable version soon. It will be included in version 14.x.9.xxxx. Please bear with us.

best regards.

Jan, 2014 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Default RDP data

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.