I want to know that my network link work properly. Maybe you have other suggestions.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

have you checked the "Additional Channels" on the SNMP Traffic Sensors? Maybe this does already help. Otherwise it might be necessary to import MIBs from the vendor with our MIB Importer to check these values.

best regards.


Sep, 2011 - Permalink

CRC errors can be obtained with locIfInCRC in the OLD-CISCO-INTERFACES-MIB (OID 1.3.6.1.4.1.9.2.2.1.1.12)

locIfInCRC OBJECT-TYPE
                   SYNTAX  INTEGER
                   ACCESS  read-only
                   STATUS  mandatory
                   DESCRIPTION
                           "Number of input packets which had cyclic
                           redundancy checksum errors."
                   ::= { lifEntry 12 }

Sep, 2011 - Permalink

thanks very much for help


Sep, 2011 - Permalink

You might be able to monitor CRC errors also with the SNMP RMON Sensor if your device provides traffic data via Remote Monitoring (RMON).


Jan, 2014 - Permalink