Summary report on bandwidth utilisation
Modified on 2025-06-10 13:59:42 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
We are currently monitoring bandwith utilisation on the WAN link of a number of routers. The capacity of each link is different. Is it possible to customise a report to produce a one page summary table on a monthly basis that shows the following parameters for each router on a per row basis over a stipulated period of time?
1. Link availability
2. Percentage of Peak In
3. Percentage of Peak Out
4. Percentage of Average In
5. Percentage of Average Out
Article Comments
Natively this is not something that can be done with the reporting engine that is built in but you may want to take a look at the article that describes how to customize reports. Getting percentages of peaks may not be possible since this isn't something that is shown in any other report and there are no pre-built variables for this information though.
Custom Report Templates
Dec, 2013 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Natively this is not something that can be done with the reporting engine that is built in but you may want to take a look at the article that describes how to customize reports. Getting percentages of peaks may not be possible since this isn't something that is shown in any other report and there are no pre-built variables for this information though.
Custom Report Templates
Dec, 2013 - Permalink