Is it possible to add snmp sensors with text based values without getting an error?

Modified on 2025-06-10 13:59:45 +0200

If I add the custom snmp sensor with oid .1.3.6.1.2.1.1.1.0 to get s ystem infos. PRTG give me an nice output with all the infos (chassis type, IOS Version....) I need but marks the status as error.

Is there a way to solve this?

Best regards Robert

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi,
what precise error are you getting? Have you tried using the SNMP Custom String sensor instead of the SNMP Custom Sensor?
Best regards

Dec, 2013 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Is it possible to add snmp sensors with text based values without getting an error?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.