Solutions

Cluster Probe fehlt

Modified on 2025-06-10 13:59:53 +0200

In unserer Cluster-Installation mit 2 Nodes sehe ich nur die local Probes. Wie kann ich eine "Cluster Probe" installieren?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Wenn man eine Cluster Probe installiert, musst man diese erst hier "Active" schalten und dann kann man diese im Device Tree sehen, es sollte auf dem gleichen Level wie die Local Probe sein.

Dec, 2013 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Cluster Probe fehlt

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.