I am hitting this same error and have tried all the suggestions on this post. https://www.paessler.com/en/topic/59410-my-snmp-ibm-system-x-system-health-sensors-don-t-work-what-can-i-do

It worked for a while and then stopped and started returning this error. There seems to be no obvious configuration issue.

Other SNMP sensors works just fine. Only the System X sensors fail.

Are there any other troubleshooting steps?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

What precise error message does the sensor show, please?


Dec, 2013 - Permalink

The error message is the title of the original post. -->Could not find any IBM System Health metrics on this device. (code: PE194)


Dec, 2013 - Permalink

Hi,
could you please download the SNMP Tester and perform a walk over the OID 1.3.6.1 against the target device. Could you furthermore send the results to support@paessler.com. In the email, please refer to this article.
Best regards


Dec, 2013 - Permalink

Looks like this problem might be in the IBM platform agent. http://www-01.ibm.com/support/docview.wss?uid=isg1IC77921


Dec, 2013 - Permalink

In this case there is not much we can do about, I'm afraid.
Best regards


Dec, 2013 - Permalink