How can i enable a host header to point to prtgip address

Modified on 2025-06-10 14:00:36 +0200

i have taken over an install of prtg, i have setup the follwoing dns a record to point to the server, i get an login prompt but from there i get just an iis page i wish to browse to the prtg installation from a hostname

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi,
you can set a custom DNS name in PRTG itself. The web server will then listen to the set up DNS name as well as to the IP address. In the web interface, just go to Setup | System & Website, there provide the DNS name under setting DNS Name. Now you should be able to use the web interface with the hostname.
Best regards

Dec, 2013 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How can i enable a host header to point to prtgip address

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.