Solutions

Line graph has become a bar graph

Modified on 2025-06-10 14:01:19 +0200

After upgrading to latest version, a graph that used to display as a line graph is now showing as a bar graph. Graph

Has there been a change?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi,
what precise version of PRTG are you using?
Best regards

Nov, 2013 - Permalink

We are using 13.4.7.3532 We found the source. The sensor creating the graph is a factory, and there were was a difference in the scan interval with some of the source sensors. Once they were all set to the same interval, the graph showed properly again.

Dec, 2013 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Line graph has become a bar graph

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.