Solutions

Total output drops

Modified on 2025-06-10 14:01:27 +0200

When I do an Show interface I'm getting alot of "Total output drops: " On SNMP sensor is that the Discards? If not is PRTG able to monitor the total output drops, and if so how would I set that up?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi,
by standard PRTG is not able to monitor the OutputDrops. You might use a MIB file provided by Cisco and import the same to PRTG using the MIB Importer. Please see this thread in the Cisco Support Forums where the topic itself, needed OIDs and MIBs is covered as well.
Best regards

Nov, 2013 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Total output drops

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.