How to show an icon and total bandwith under it on Map?

Modified on 2025-06-10 14:01:48 +0200

I'm have a map of couple routers(Icons C) that shows how many sensors each has and if they are in Up state.

What I want to do is show xFlow's total bandwidth usage under each of the router's icons instead. Is that possible?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

thank you very much for your KB-Post. This should be possible. Just make sure the Total-Channel of the flow-sensor is set as the Primary Channel, and then for example use the Status and Last Value (On White) Map object::

best regards.

Nov, 2013 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How to show an icon and total bandwith under it on Map?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.