I added jitter sensor via cisco ip sla, but got msg in subj.

Cisco Cat6509 IOS s72033-ipservicesk9_wan-mz.122-33.SXH6.bin.

I use SNMP ver 2c and community public.

The sla monitor itself is ok as per output from catalyst

Another sensor is working fine (ip sla echo)

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

which exact version of PRTG are you running?

best regards.


Jul, 2011 - Permalink

PRTG Network Monitor 8.4.2.2380


Jul, 2011 - Permalink

Other SNMP sensors do work on the device?


Jul, 2011 - Permalink

yes

as I said the other IP SLA Echo sensor is fine


Aug, 2011 - Permalink

Please switch to SNMP v1 for the device in case and try adding the jitter sensor again. If this doesn't work, please send an email to support@paessler.com referring to this knowledge base case and we will forward you further testing information.

Please have also a look at this article.


Aug, 2011 - Permalink