Solutions

Class Based QoS not appearing

Modified on 2025-06-10 14:04:54 +0200

We have recently upgraded to the latest version of PRTG and I have been looking at the new CBQoS sensors. On our routers we have a lot of class based QoS configured however hardly any of the classes appear in PRTG. Is there anything else I need to enable or do to be able to view the full list of sensors? Many thanks.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

We monitor all of these stats though SNMP. Can you please try performing a walk with the SNMP Tester on the OID 1.3.6.1.4.1.9.9.166.1.5.1.1 and post the results here?

Oct, 2013 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Class Based QoS not appearing

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.