Solutions

autobackup of version 13.3.5

Modified on 2025-06-10 14:05:13 +0200

Hi. When i was on a older version, there would be a autobackup of my configuration files. I dont see this happening on the new version. How can i configure that?

Thanks, Perry

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi Perry,
nothing has been changed in the autp back up process of the configuration. The backups still should be written to the sub folder Configuration Auto-Backups of your PRTG data directory.
May you check the same when the last one was written?
Best regards

Oct, 2013 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

autobackup of version 13.3.5

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.