How to monitor IBM SAN Volume Controller?
Modified on 2025-06-10 14:06:20 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
Hello,
I want to Monitor a IBM SAN Volume Controller (SVC) with PRTG.
Is there an easy way to get the Performance data out of the SVC.
I want to see the latency of the virtual disks and the CPU utilization.
It would also be nice to see the read/write times for each virtual disk.
Can you please help me with this issue?
Best regards
Article Comments
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
thank you very much for your KB-Post. Please check if the vendor of your device offers any MIB-Files that you can import with our MIB-Importer to monitor the target then with SNMP Library Sensors.
It seems there are MIBs IBMs SVCs available
best regards.
Oct, 2013 - Permalink