HTTP Full Web Page Sensor discrepancy between engines

Modified on 2025-06-10 14:07:23 +0200

When using IE as the browser engine, I get a load time of about 6 seconds for the site I am monitoring.

However, when using Chromium of Phantom/JS as the engine, my load time is 70 ms.

After some packet captures, it appears that Chromium and Phantom do not follow the redirects and only report back on the initial request.

Can this be changed so that the full page is loaded just like when using the IE engine?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

actually it's the other way round. The IE engine doesn't follows redirects and Chromium should do so.

Could you please open a support ticket by sending a mail to support@paessler.com and give us an example which Url you are monitoring.

Regards, Thomas

Sep, 2013 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

HTTP Full Web Page Sensor discrepancy between engines

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.