how to distinguish mulitple ipsec vpn tunnel monitors on netscreen

Modified on 2025-06-10 14:07:53 +0200

I am using Juniper SSG and has multiple ipsec VPN tunnels running. I already got the OID that monitors the tunnel status (established or disconnected). However, when I let prtg scan the tunnels to create a monitor, it just shows numbers and codes that I do not have idea about. how can I determine which tunnel is that code for?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi please send a screen shot about the output you get to support@paessler.com

Sep, 2013 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

how to distinguish mulitple ipsec vpn tunnel monitors on netscreen

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.