Which OID to use when setting up SNMP Trap Sensor

Modified on 2025-06-10 14:08:40 +0200

I am reviewing the list of incoming SNMPv2-trap packets and am curious as to which OIDs I need to specify when setting up an SNMP Trap Receiver.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

SNMP v2 traps are not supported at the moment.

please take a look at

https://www.paessler.com/en/topic/143-how-can-i-use-prtgs-trap-receiver-and-what-are-its-limitations

but we are working on a complete makeover for the SNMP Traps and Syslog capabilities of PRTG, which will make it a lot more flexible.

But this will probably not be available in a stable version before Q1 2014

Sep, 2013 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Which OID to use when setting up SNMP Trap Sensor

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.